How To Set Up A Wireless IP Dome Camera Outside And Inside The Home
Example Wireless IP Camera Set-up.
This video takes a look at the setup of a specific wireless IP camera inside a home.
A wireless IP dome camera has the benefit of being able to operate effectively on the inside and the outside of a home because no cables are involved.
To mount a wireless IP dome camera, you have to buy wireless video camera equipment from a surveillance equipment shop or a security service center. The wireless video camera equipment includes not less than two cameras, one designed for indoor use and also the other intended for outdoor. No PC networking skills is needed since the wireless network is automatically fired up once the IP dome cameras have been configured.
Setting up process
On both wireless video cameras, open the medial side panels and adjust the “Channel” setting on IP dome camera to some special number and letter, like, in the event point; set someone to “A1” plus the other to “A2.” Then shut the medial side panels.
Bolt inside the video camera mounting plane towards the wall in the location you want to stay under surveillance using a screwdriver, wood screws are recommended. However, you are able to bolt metal screws around the sides of the IP dome camera along with into the mounting plate. Angle the outdoor antenna around the IP camera, which is – if there’s one, towards the TV that will be utilized to observe its video. Plug in the power cable from you into a wall power outlet.
Drop the circuit breaker around the fuse box which is providing electrical power to a exterior electric junction box, just to illustrate, you can use the light over a garage or the porch light. Unfasten the screws that are around the lighting pleat, which should be location in which you will be mounting the external IP dome camera.
Pull the pleat around the wall. Unfasten the screw-tab connectors above the twisted pairs of black and white cables that are now exposed behind the pleat. Wrap the black wire from the back of the camcorder around the black wires from the hole. Wrap the white wire from the flip side of the IP dome camera about the white wires from the hole.
Bolt the lighting pleats back around the wall using wood screws using. Bolt it IP dome camera wall case around the wall beside the pleat with wooden screws. Bolt metal screws throughout the sides of the IP dome camera and to the case wall. Turn on the electric power on the fuse box. Place the wireless video IP camera receiver near to the TV. Plug in one tip of the video cable towards the video output end of the receiver. Plug in it cable’s other tip in to a video input in the TV – normally around the back panel.
Shop for your wireless IP dome camera on Amazon.
Other posts you may like: